Name: Republic Locker RH Lift Only for Recessed Locker Door Handle Assembly
Brand: Republic Storage Systems, LLC
SKU: RS-2008-RH
Price: 17.76 USD
Availability: InStock

Republic Locker RH Lift Only for Recessed Locker Door Handle Assembly

SKU:

RS-2008-RH

MFG Part #:

7137185

Description

DESCRIPTION

Slide plate mechanism for Republic Steel recessed handle cup.

Material	: Steel
Thickness	: 1/16"
This item is a piece of steel with cutouts and 90 degree bends in it. As the piece faces you, with three of the four bends facing you one
bend facing away from you, it consists of the following	:
- A mounting side on the left, which is bent forward and has an
upper portion, a lower portion, and a cutout gap between.
Each portion has a finger tab, which fits into and secures the
lift onto the lockbar
- A back portion
- A tab on the top right, which is bent forward and provide a place
to mount the plastic trigger
- A tab on the bottom right, which is bent back and has a squared
cutout for the combination lock bolt to rest in when it's in the
locked position. The square cutout continues into part of the
back portion.
Height of lift	: 4-5/16"
Left side mounting portions
Top portion
Height	: 1-/16"
Depth	: 1-1/16"
Finger tab
Width	: 1/8"
Length	: 1/4"
Bottom portion - is deeper at the top than the bottom
Height	: 1-21/32"
Depth at top	: 1-5/16"
Depth at bottom, where finger tab is	: 1-1/6"
Finger tab - goes left off the bottom portion, then takes a
90 degree bend to point down.
Length of left portion
At inside corner	: 3/32"
At outside corner	: 1/4"
Length of down portion
At inside corner	: 3/32"
At outside corner	: 1/4"
Back portion
Height	: 4-5/16"
Width
At top, where top left portion and right plastic trigger
mounting are is	: 2-17/32"
At middle	: 1-3/8"
At bottom, including lower left portion and right lock
cutout tab	: 1-19/32"
At bottom, up to, but not including lock cutout	: 1-1/16"
Lock cutout
Height	: 7/8"
Width	: 7/16"
Right portions
Top tab for plastic trigger mount
Height	: 1-1/6"
Depth top is narrower than the bottom
To top	: 5/8"
At bottom	: 1-3/16"
Padlock hole
Dia	: 3/8"
Distance of hole from bottom of tab	: 3/16"
Distance to hole from back of tab, where it joins the
back plate	: 11/16"
There is a small finger tab that is lifted out of the surface of
the right side of this portion about 40 degrees, and, as you
face it, goes in a direction of about a 2	: 00 position on a clock.
The plastic trigger snaps down over this.
Width	: 5/32"
Length	: 7/32"
Height off surface	: 1/8"
Bottom tab with lock cutout
Height
Outside	: 1-13/16"
Inside	: 7/8"
Depth
Outside	: 23/32"
Inside	: 71/6"

Questions about Republic Locker RH Lift Only for Recessed Locker Door Handle Assembly?

Please contact us with any questions you have about Republic Locker RH Lift Only for Recessed Locker Door Handle Assembly and we'll be in touch.